Build
FAA Proposes Two Airworthiness Directives; FHWA Seeks OMB Renewal on Highway Reporting
The FAA has issued back-to-back NPRMs covering engine shock mounts on Tecnam light twins and overhead bin attachments on the Airbus A320 family, while FHWA moves to renew two information collections tied to performance reporting and project agreements.
FAA: Tecnam P2006T Engine Shock Mount AD
The FAA proposes a new airworthiness directive (AD) for all Costruzioni Aeronautiche Tecnam S.P.A. Model P2006T airplanes, acting under 14 CFR 39. The proposed AD was prompted by a report of damage on the engine mount structure caused by defective non-conforming engine shock mounts being installed. According to the notice, the European Union Aviation Safety Agency (EASA) issued EASA AD 2026-0071, dated March 31, 2026, to correct this unsafe condition on Tecnam Model P2006T and P2006T NG airplanes.
The EASA action found that damage on the engine mount structure was caused by non-conforming defective engine shock mounts. The unsafe condition, the notice states, if not addressed, could result in the engine disconnecting from the airplane structure and loss of control of the airplane. The proposed AD would require inspecting for the installation of non-conforming engine shock mounts and replacing any non-conforming engine shock mount with an approved part, and would also prohibit installation of a non-conforming engine shock mount on any airplane. The FAA reviewed Tecnam Service Bulletin SB 969-CS-Ed. 3, Rev. 1, dated April 3, 2026, which specifies procedures to inspect and identify non-conforming engine shock mounts having part number CONO21-BS and batch number 49-24 or 11-25. The FAA estimates that this AD, if adopted as proposed, would affect 131 airplanes of U.S. registry. Comments must be received by December 21, 2026, under Docket No. FAA-2026-13799.
FAA: Airbus A320-Family Overhead Stowage Compartment AD
In a separate NPRM also under 14 CFR 39, the FAA proposes an AD for certain Airbus SAS Model A318, A319, A320, and A321 airplanes. The action was prompted by reports of damage to the YZ-axis attachment points on airplanes equipped with certain overhead stowage compartment (OHSC) bins supplied by ARIES. Investigations revealed that bushings (also called bearings), retainer rings, and pins had migrated from their original positions, possibly due to axial loading and/or improper maintenance during bin removal or reinstallation.
The unsafe condition, if not addressed, the notice states, could affect the structural integrity of the OHSC under emergency landing loads, which could lead to OHSC detachment, possibly resulting in injury to airplane occupants and/or blocking of an escape path during an emergency evacuation. The underlying EASA action is EASA AD 2025-0248, dated November 6, 2025. The proposed AD would require a one-time general visual inspection (GVI) of the OHSC housing side attachment on the left-hand and right-hand sides for any discrepancies—including corrosion or damage on the pin or bushing, or any loose, migrated, damaged, or missing bushing or retainer, or any bushing bedding damage or ovalization—and, depending on findings, accomplishment of applicable corrective actions. Corrective actions include a special detailed inspection (SDI) of the bushing bedding condition, repairing the OHSC housing side attachment, and contacting the manufacturer for repair instructions. The proposed AD would also prohibit the installation of affected parts. Note that Model A320-215 airplanes are not certificated by the FAA and are excluded from this proposed AD's applicability. Comments are due by December 21, 2026, under Docket No. FAA-2026-13800.
FHWA: Two Information Collection Renewals Under the Paperwork Reduction Act
The Federal Highway Administration has initiated two separate Paperwork Reduction Act renewal actions targeting state transportation agencies.
The first, already forwarded to the Office of Management and Budget (OMB), concerns Transportation Performance Management (TPM) Biennial Reports, governed by 23 CFR part 490. The notice explains that FHWA is responsible for collecting information required by Congress in 23 U.S.C. 119 and 150 and codified in 23 U.S.C. Part 490. A prior 60-day comment period published August 26, 2026, at 91 FR 55157 received 5 comments. Commenters included the Transportation Departments of Idaho, Montana, North Dakota, South Dakota, and Wyoming (via a joint letter), the Missouri Department of Transportation, the Oklahoma Department of Transportation, and the American Association of State Highway and Transportation Officials (AASHTO). Those commenters urged FHWA to initiate an Advance Notice of Proposed Rulemaking to revise 23 CFR part 490, reduce NHS reporting requirements in rural areas, and adopt a "collect once, use many times" approach. FHWA responded that modifications to 23 CFR part 490 and changes to definitions are outside the legal scope of the PRA clearance docket. Comments on this renewed collection are due December 7, 2026.
The second collection renewal covers the Preparation and Execution of the Project Agreement and Modifications (OMB Control No. 2125-0529). The notice explains that formal agreements between State Transportation Departments and FHWA are required for Federal-aid highway projects, and that Section 1305 of the Transportation Equity Act for the 21st Century (TEA-21, Pub. L. 105-178) amended 23 U.S.C. 106(a) to combine authorization of work and execution of the project agreement into a single action. The collection covers 56 respondents, including 50 State Transportation Departments, the District of Columbia, the Commonwealth of Puerto Rico, the Commonwealth of the Northern Mariana Islands, Guam, the Virgin Islands, and American Samoa. The notice states there are a total of 19,522 agreements per year, each requiring 1 hour to complete, for an estimated total annual burden of 19,522 hours. Comments are due January 4, 2027, via DOT Docket ID Number 1223.
What to watch
- December 7, 2026 — FHWA comment deadline for TPM Biennial Reports PRA renewal.
- December 21, 2026 — FAA comment deadline for both the Tecnam P2006T engine shock mount NPRM (Docket No. FAA-2026-13799) and the Airbus A320-family OHSC NPRM (Docket No. FAA-2026-13800).
- January 4, 2027 — FHWA comment deadline for the Project Agreement and Modifications PRA renewal (DOT Docket ID 1223).
What this means for recipients
State, local, and tribal transportation agencies that execute Federal-aid highway project agreements face a reporting burden estimated at 19,522 hours annually and should review FHWA's proposed renewal terms before the January 4, 2027 comment deadline. State DOTs subject to 23 CFR part 490 TPM reporting have until December 7, 2026 to submit comments on the biennial reporting collection renewal, though FHWA has stated that changes to the underlying regulatory requirements or definitions are outside the scope of this PRA action. Aviation operators and maintenance organizations responsible for Tecnam P2006T or Airbus A320-family aircraft equipped with ARIES OHSC bins should track both FAA NPRMs, as the proposed ADs would impose inspection and replacement obligations and prohibit installation of identified non-conforming parts once finalized.
Related
- Build hub
- FAA Issues Final Airworthiness Directive for Boeing 757 and 767 Over 5G C-Band Radio Altimeter Interference in Canadian Airspace
- FERC Advances Four Energy Infrastructure Proceedings; FAA Issues Immediate Boeing 737 Airworthiness Fix
- FERC Discloses Exempt Off-the-Record Communication in Docket ER26-2389-000
Sources
23 citedEvery hard fact above is grounded in and cited to a primary source record.
-
The FAA proposes a new airworthiness directive for all Costruzioni Aeronautiche Tecnam S.P.A. Model P2006T airplanes under 14 CFR 39.
federalregister.gov -
The proposed Tecnam AD was prompted by a report of damage on the engine mount structure caused by defective non-conforming engine shock mounts being installed.
federalregister.gov -
EASA issued EASA AD 2026-0071, dated March 31, 2026, to correct the unsafe condition on Tecnam Model P2006T and P2006T NG airplanes.
federalregister.gov -
The unsafe condition, if not addressed, could result in the engine disconnecting from the airplane structure and loss of control of the airplane.
federalregister.gov -
The proposed Tecnam AD would require inspecting for the installation of non-conforming engine shock mounts and replacing any non-conforming engine shock mount with an approved part, and would prohibit installation of a non-conforming engine shock mount on any airplane.
federalregister.gov -
The FAA reviewed Tecnam Service Bulletin SB 969-CS-Ed. 3, Rev. 1, dated April 3, 2026, which specifies procedures to inspect and identify non-conforming engine shock mounts having part number CONO21-BS and batch number 49-24 or 11-25.
federalregister.gov -
The FAA estimates that the Tecnam AD, if adopted as proposed, would affect 131 airplanes of U.S. registry.
federalregister.gov -
Comments on the Tecnam NPRM must be received by December 21, 2026, under Docket No. FAA-2026-13799.
federalregister.gov -
The FAA proposes an AD for certain Airbus SAS Model A318, A319, A320, and A321 airplanes under 14 CFR 39, prompted by reports of damage to the YZ-axis attachment points on airplanes equipped with certain OHSC bins.
federalregister.gov -
Investigations revealed that bushings, retainer rings, and pins had migrated from their original positions, possibly due to axial loading and/or improper maintenance during bin removal or reinstallation.
federalregister.gov -
The unsafe condition could affect the structural integrity of the OHSC under emergency landing loads, which could lead to OHSC detachment, possibly resulting in injury to airplane occupants and/or blocking of an escape path during an emergency evacuation.
federalregister.gov -
The underlying EASA action is EASA AD 2025-0248, dated November 6, 2025.
federalregister.gov -
The proposed Airbus AD would require a one-time general visual inspection of the OHSC housing side attachment on the left-hand and right-hand sides for any discrepancies and, depending on findings, accomplishment of applicable corrective actions.
federalregister.gov -
Model A320-215 airplanes are not certificated by the FAA and are excluded from this proposed AD's applicability.
federalregister.gov -
Comments on the Airbus OHSC NPRM are due by December 21, 2026, under Docket No. FAA-2026-13800.
federalregister.gov -
FHWA forwarded the TPM Biennial Reports information collection renewal to OMB; comments are due December 7, 2026.
federalregister.gov -
A prior 60-day comment period on the TPM collection was published August 26, 2026, at 91 FR 55157, and received 5 comments.
federalregister.gov -
FHWA stated that modifications to 23 CFR part 490 and changes to definitions are outside the legal scope of the PRA clearance docket.
federalregister.gov -
Section 1305 of TEA-21 (Pub. L. 105-178) amended 23 U.S.C. 106(a) to combine authorization of work and execution of the project agreement for a Federal-aid project into a single action.
federalregister.gov -
There are a total of 19,522 agreements per year, each requiring 1 hour to complete, for an estimated total annual burden of 19,522 hours.
federalregister.gov -
Comments on the Project Agreement and Modifications renewal are due January 4, 2027, via DOT Docket ID Number 1223.
federalregister.gov -
Commenters on the TPM renewal included the Transportation Departments of Idaho, Montana, North Dakota, South Dakota, and Wyoming via a joint letter, plus MoDOT, ODOT, and AASHTO.
federalregister.gov -
The Project Agreement and Modifications collection covers OMB Control No. 2125-0529 and involves 56 respondents, including 50 State Transportation Departments, the District of Columbia, the Commonwealth of Puerto Rico, the Commonwealth of the Northern Mariana Islands, Guam, the Virgin Islands, and American Samoa.
federalregister.gov